Skip to content
Chimney Repair Hillside

Chimney Repair Service in Hillside

Hillside Illinois chimneys are exposed to very heavy weather effects – strong wind, very cold/snowy winters, rain – while in the same time they are heated by hot gases from fire. That can cause a lot of deterioration, cracking and movement to your chimney.

Licensed and Fully Insured Serving Hillside and the Surrounding area.

Roofing License
IL License # 104-012713

Repairs of your chimney may include repointing or rebuilding the firebox (where fire is built). Sometimes the damper needs to be repaired, so it can close properly the flu so heat wont escape through the chimney.

The mortar crown is the concrete or stone surface at the top of the chimney that keeps water out of flue. That part of your chimney should be repaired immediately when it’s cracked or broken – so you can avoid future serious water damages and huge repair costs. If you will leave it un-repaired it will provide the easy for water to penetrate the masonry. Then freeze cycles will cause masonry deteriorate. Un-repaired can release dangerous gases inside your home or even flames and sparks that can create a fire hazard.

Getting Started

If you need more information about our Chimney Repair Services use our contact form to get in touch. Or if you want to get a free estimate on next job – use our Online Free Estimate Form.

Testimonials

“Mark’s Tuckpointing has a great staff that provides free estimates at a reasonable rate. They are willing to work within your time table.My wish is the the Condo Association sees things as I do. They did a great job!”

Scott H. [yelp.com]

“Peter was very helpful throughout the process. Him and his team did a great job tuckpointing and fixing our condo building’s gutter. Their price was reasonable and they did not try to convince us to do additional work (like some contractors did). We were very happy with the quality of their work.”

Julie A. [yelp.com]

Helpful Information

  • All mortar used for the tuckpointing is a 3:1 mix, (3) parts of fine aggregate “Bank Sand” mixed with (1) part of masonry type “N” cement, (3) trowles of lime, and (3) trowels of Portland cement.
     
  • All mortar used for the bricklaying is a 2:1 mix, Portland and lime mixed with #2 sand aggregate.
     
  • Percentage/square footage of wall areas to be spot-tuckpointed, will be determined by Contractor and specified in the contract
     
  • Contractor is not responsible for settlement cracks and efflorescence forming on brick or mortar, due to moisture retention of the brick.